ADTRAN TOTAL ACCESS 600R, System Manual

Page: 53 / 196

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 53
The remaining Syslog parameters have the following level choices:
FATAL (Highest priority)
ALERT
CRITICAL
ERROR
WARNING
NOTICE
INFO
DEBUG (Lowest priority)
Every log message generated by the IAD has a reporting level priority. If the message priority is lower than
the configured priority for the destination log, the message is not forwarded to the syslog daemon. See
RFC3164: The BSD Syslog Protocol. The lower the log level, the more messages that will be generated.
Setting reporting levels to DEBUG may negatively affect the performance of the IAD, including causing
the IAD to reset.
SYSLOG using Terminal Mode
Another option for configuring syslog is using the terminal mode command log dump <logname> . The
logname must be all CAPS and be one of the following names:
FATAL
ALERT
CRITICAL
ERROR
WARNING
NOTICE
INFO
DEBUG
The command will dump all messages for the indicated log (
ALL L
EVEL
shows all log messages) stored in
the internal log buffer to the command line display.
S
YSTEM
C
ONFIG
> S
YSLOG
> ALL L
EVEL
This entry allows setting the default reporting level for all log entries. If
ALL L
EVEL
is a lower priority than
the individual log entry level,
ALL L
EVEL
overrides the individual log reporting level.
S
YSTEM
C
ONFIG
> S
YSLOG
> KERNEL L
EVEL
Minimum required level for sending KERNEL log messages.
ADTRAN recommends using DEBUG for only short periods of time for debug purposes
only.