SmartRG Inc., an ADTRAN Company Proprietary and Confidential. All Right Reserved. © 2020
78
Field Name
Description
Ether Type
Select the Ethernet interface type for this classification. Options include
IP
,
ARP
,
IPV6
,
PPPoE
, and any other Ethernet interface defined for your network.
Source MAC Address / Mask
(
Available for LAN, ATM, ETH, PPP-Routed and wireless interfaces only
) Enter the source
MAC address and source MAC mask for this classification.
Destination MAC Address / Mask
(
Available for LAN, ETH and wireless interfaces only
) Enter the destination MAC address and
destination MAC mask for this classification.
Source IP Address [/ Mask]
or
Vendor
Class ID
or
User Class ID
(
Available for WAN, ATM and PPP-Routed interfaces only
) Select the source for this
classification. Options are:
l
Source IP Address[/Mask]
: Enter the source IP address and source IP mask.
l
Vendor Class ID (DHCP Option 60)
: Enter the vendor class ID.
l
User Class ID (DHCP Option 77)
: Enter the user class ID.
Destination IP Address
[/ Mask]
(
Available for WAN and ATM interfaces only
) Enter the destination IP address and source IP
mask for this classification.
Differentiated Service Code Point
(DCP) Check
(
Available for WAN, Local, ATM, and PPP-Routed interfaces only)
Select the DSCP check
protocol. Options include
default
and a range of protocol IDs.
Protocol
(
Available for WAN, Local, and ATM interfaces only
)Select the protocol specified for this
classification. Options are
TCP
,
UDP
,
ICMP
, and
IGMP
.
UDP/TCP Source Port
(
Appears when
TCP
or
UDP
is selected in the
Protocol
field
) Enter the source port to be
used for this classification. You can enter a range (port:port) or a single port.
UDP/TCP Destination Port
(
Appears when
TCP
or
UDP
is selected in the
Protocol
field
) Enter the destination port to
be used for this classification. You can enter a range (port:port) or a single port.
Specify Classification Results
section
Specify Egress Interface
Select an interface for outgoing traffic. Options include any interface defined for your
network.
Specify Egress Queue
Select from the available queues.
Note:
Make sure to select a queue that is defined for the interface that you selected. If you
select a queue that is not defined for the selected interface, any packets classified into that
queue are processed by the default queue for the interface.
Mark Applied Differentiated Service
Code Point
Select the desired DSCP code.
Set Rate Limit
Enter the data traffic rate limit for this classification in kilobits per second.
QoS Port Shaping
On this page, you can configure a fixed rate (Kbps) for each of the Ethernet ports.
1. In the left navigation bar, click
Advanced Setup
>
Quality Of Service
>
QoS Port Shaping
. The following page
appears.
