ADTRAN NetVanta 2730, Getting Started Manual

Page: 23 / 74

Page 18 Initializing the NetVanta 2730
Initializing the NetVanta 2730
To begin deployment of your ADTRAN NetVanta 2730
appliance, first insert the WWAN PC card and then apply power
to the appliance.
Inserting the WWAN PC Card
Before inserting the WWAN PC card into your ADTRAN
NetVanta 2730 appliance, be sure your WWAN PC card is
activated and unlocked. If you are not sure whether your card is
unlocked or not, contact the PC card vendor to verify.
Alert:
Do not insert or remove the WWAN PC card while the
ADTRAN NetVanta 2730 is powered on.
1. Ensure that the ADTRAN NetVanta 2730 is not connected
to a power source.
2. Insert your WWAN PC card “face up” into the PC CARD
slot on the left side of the ADTRAN NetVanta 2730
appliance. The card should sit firmly in place.
Applying Power
1. Connect the AC plug to the power supply.
2. Plug one end of the power supply to the back of the
ADTRAN NetVanta 2730.
Warning:
ADTRAN power supplies are platform specific. Do
not use power supplies from other ADTRAN
platforms.
3. Connect the AC plug to an appropriate power outlet.
The Power LED on the front panel lights up blue when you
plug in the ADTRAN NSA. The Test LED will light up and
may blink while the appliance performs a series of diagnostic
tests.
When the Power LED is lit and the Test LED is no longer lit, the
ADTRAN NetVanta 2730 is ready for configuration. This
typically occurs within a few minutes of applying power to the
appliance. If the Test LED remains lit after the ADTRAN
NetVanta 2730 appliance has been booted, restart the
appliance by cycling power.
To AC power
3 5 6 Power