ADTRAN DSU IV ESP, User Manual

Page: 95 / 194

Chapter 10. Management Functions
61204011L1-1 DSU IV ESP User Manual 10-3
Interface
Select the management interface type (VT 100 terminal, SLIP, or
PPP) or select Ethernet LAN (ESP Ethernet card must be installed).
Control Rate
Select the control port operating speed to match the connected
device (this selection only applies when the interface options is set
for VT 100 terminal, SLIP, or PPP).
IP Options
Unit IP Address
Enter the DSU IV ESP IP A
DDRESS
in dotted decimal notation.
Subnet Mask
Enter the subnet number in dotted decimal notation. This address
is available from the network administrator.
Gateway IP Address
Enter the G
ATEWAY
N
ODE
IP A
DDRESS
in dotted decimal notation.
This address is necessary only if the DSU IV ESP and network
manager are connected through a Gateway node. If an IP packet
with an unknown IP address is received, the DSU IV ESP sends it to
the Gateway.
IP Security
Enable/disable the IP S
ECURITY
option. If enabled, the DSU IV ESP
only accepts management commands from the IP addresses (up to
5) entered into the
IP F
ILTER
A
DDRESS
field.
IP Filter Address
Enter the IP addresses of the management stations from which the
DSU IV ESP should accept management commands. This filter
must be enabled though the IP Security field.
When configuring the DSU IV ESP with the front panel, use
the "*" key to enter a decimal point.