ADTRAN 1200275L1, User Manual

Page: 91 / 198

Chapter 7. Configuring the Network Port
61200275L1-1 TSU IQ+ User Manual 7-5
The status of the connection can be viewed in the
S
TATISTICS
menu
under
N
ETWORK
P
ORT
S
IGNALING
S
TATE
(see Signaling State on
page 10-6). The status will return to active again once the threshold
is no longer exceeded.
Range:
1
to
10
.
Management DLCI 1 and 2 (DLCI 1 and 2)
Enter the management data link connection identifiers (DLCIs).
These DLCIs are used to carry management traffic to and from the
network.
Range:
16 to 1007 .
Management DLCI 1 and 2 Mode (DLCI 1 and 2 MODE)
Set to D
EDICATED
if the management DLCI is used only to manage
the TSU IQ+ (and not used to carry customer traffic). If set to
D
EDICATED
, the router is not notified of that DLCI. Set to S
HARED
if
the management DLCI is used for carrying customer traffic and
management data.
Choices:
S
HARED
; D
EDICATED
.
Maximum PVC Count
Set the maximum number of PVCs that the TSU IQ+ will monitor
for statistical information. This value determines the amount of
history intervals available for storage. To get the maximum amount
of statistical history storage, set this value equal to the number of
PVCs assigned to the frame relay port. A smaller value increases
history interval count but puts some of the PVC statistics into the
unknown category.
Range:
1 to 100 .
The network service provider should recommend the values entered into
the T391, N391, N392, and N393 fields.