ADT-09 Series Motion Control Card
40
Tips
During the debugging process, please temporarily disconnect
the control card and the terminal block from the load
if there’s no
special requirement. After the offline debugging, and make sure
that the peripheral parameters are set correctly, restore the
connection between the control card, the terminal block and the
load. In case that drive control is required, run it at low speed first
then high to prevent device fault or damage due to operational
errors during debugging.
4.1.
Establishing a communication
The communication between the PC and the control card can be the initialization
of the control card, which can be established by debugging the control card
initialization of the software. You can try to establish communication between the PC
and the 09 series motion control card by clicking the "Control Card Initialization"
button in the upper right corner.
The user interface will change as follows if the communication is successfully
established.
