Adtech 4 Series, Maintenance Manual

Page: 33 / 155

ADTECH 4 series CNC System (maintainance Manual)
29
8.2 Reading programs into work area
8.2.1 Reading programs from controller into work area
The step of loading files from controller memory into work area as follows:
➢
Press [File]
➢
Select [local disk(d)], and press [EOB]
➢
Select [PROG] folder, press [EOB] to enter
➢
Move cursor to select desired program, press [EOB] to confirm and load the program.
8.2.2 Reading programs from USB disk into work area
The step of loading files from USB disk into work area follows:
➢
Insert the USB disk;
➢
Press [File] to enter file operation interface;
➢
Select USB disk, move cursor to select a file in the disk, and press [EOB] to load the file.
8.3 Editing & modifying programs
The program in CNC memory can be edited with controller keypad. In the main menu, press [program] to
enter program edit interface and edit the program in current work area (for loading program into work
area, refer to 8.2).The program mode similar to notepad in Windows. Move the cursor directly to locate,
press keys to enter, press [EOB] to change line, and press [Delete] to delete the character where the cursor
locates.

Caution
After all operations, press Reset to save the files, and this functions base on program mode;
CNC49XX uses new file mapping technology, and allows loading processing files that exceed its memory.
Therefore, to ensure the system efficiency, you can only search and process, but can‘t edit the program that
exceed 2MB.
8.4 Deleting files
8.4.1 Deleting files in memory
Follow the below steps to delete the programs in controller memory:
➢
Press [File]
➢
select the file and press [Delete] ,when show a dialog ,press [EOB] to confirm and delete the file.

Caution
➢
If the program has been loaded into work area, you need to reboot the controller after deleting the
program, or else the comtroller will report error.