TSSC System Manual
https://alpha.adt.com/help/65[11/12/2018 9:42:14 PM]
the system functions.
To add a user, enter the [master code] + [8] + 2 digit user [#] + single digit authority level.
Authority Levels:
Master:
Reserved for user number 01. Can perform all functions and assign codes.
Standard:
Can perform only security functions.
Arm Only:
Can only arm the system, cannot disarm or do any other functions.
Guest:
Can arm the system but cannot disarm the system unless the system was armed with this
code. This code is ideal for a trusted babysitter or cleaner who has to arm/disarm only at certain
times.
Duress Code:
Intended for use when forced to disarm or arm the system under threat. When used,
this system will act normally, but will silently notify the Customer Care Center of yor situation, if that
service is provide.
To change a user’s code, enter the [master code] + [8] + 2 digit user 4 digit new user code.
To change the master user code, enter the current [master user code] + [8] + 01 + 4 digit new code + 4
digit new code again.
To delete a user, enter the [master code] + [8] + 2 digit user code to be d [#] + [0]. A
confirmation tone will be heard when the code is no longer functional.
System Testing
Testing Your System
Testing allows for each protection point to be checked for proper operation. While the touchpad will beep
every 40 seconds during TEST mode, no alarm messages will be sent to the Customer Care Center. We
recommend testing the system once a month.
To test the system:
1. Log into your MyADT account
2. Click on ‘My Alarm’
3. Click on ‘System Management’
4. Click on ‘Place System On Test’
5. When the system is in test mode, arm your system as you normally would using your security code.
6. Trigger an alarm by opening a door or window and allow the siren 60 seconds to run (Note: For
wireless motion detectors, allow 3 minutes between activations).
7. After 60 seconds, turn off the alarm as you normally would with your security code.
8. Verify the event by clicking on My Alarm -> Activity Reports -> Alarm Activity.
