Site Preparation and Installation Supplement
Unpacking the System
Advanced Dicing Technologies Ltd
.
16
Note:
The system is shipped with bright yellow securing jigs that prevent the
spindles, and all axes, from moving during shipment.
Caution:
When removing the X Axis securing jig, you must supply air to the X
Axis assembly in order to prevent damage to the air bearings.
Figure 7. Y and Z Jigs
a.
Remove the single screw from the yellow Y jig and remove the jig
from the Y Axis:
Replace the screw into the Y Casting (as it holds the Y Axis
in place).
Make sure that you remove the red warning label.
Figure 8. Y Jig
3.
Open the lower-rear panel and remove the two Desi Paks from the
controllers.
4.
Open the left panel and remove the two screws securing the X jig to
the end of the X Axis. Make sure that you remove the red warning
label.
Y Securing Jig
Z Securing Jig
Y Securing Jig