OPD9000 series
−
Instruction manual v1.0
24
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
9 Removing the device
1. Loosen the clamping screws by turning counter-
clockwise (5 mm hex socket).
2. Push the
clamps completely into the housing
against the spring pressure.
3. Tighten the clamping screws counter-clockwise
as far as they will go, so that the
clamps are
fixed in the housing
and do not prevent the
device from being removed from the wall recess.
4. Remove device from the wall recess.
ATTENTION
Depending on the installation situation, have a person hold the front of the device, if needed to
prevent it from falling down after the clamps are loosened.
