IPC9000 Serie
−
Instruction manual v1.1
16
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
4 Mechanical installation
The device is intended to be fastened to a screw-on wall bracket (included in the scope of delivery). The
device is not intended for installation on top-hat rails.
4.1 Requirements
Make sure that the attachment surface can safely bear the weight of the device under all operating
conditions. Use suitable screws, anchors or braces to securely attach the device depending on the load-
bearing capacity of the surface.
4.2 Attaching the wall bracket
Tip: the wall bracket can also be used as a drilling template.
Use 5 mm diameter screws on washers.
Recommendation for use
The screw head with washer may protrude no more than 4.5 mm beyond the wall
bracket. If necessary, use screws with low-profile screw heads (e.g. according to
ISO 7380).
Dimensional drawing of wall bracket: see section 11.2.
122
m
m
Below
Max. 4.5 mm
Top
