ADRF PSR-78-9533-UA, Manual

Page: 30 / 60

Advanced RF Technologies, Inc. 30
6. ADRF-BBL/BBS-U INSTALLATION
6.1 Installation Procedures
The ADRF-BBL/BBS-U battery backup unit houses two 12V batteries that are connected in series to have a
nominal voltage of 24VDC. The battery charger is built into the PSU located inside of the PSR-78-9533/9537-U.
When the system is being powered by AC, the PSU will charge the ADRF-BBL/BBS-U battery backup. When
there is a loss of primary power (AC), then repeater will switch over to the secondary power (DC) provided by
the battery backup. Once the primary power is restored, the PSR-78-9533/9537-U will switch back to
operating with AC power and will resume charging the battery backup.
1. Verify that the repeater has been properly grounded.

2. Loosen each wheel lock by spinning the red dial to the left.


3. Move the ADRF-BBL-U-24 to the desired location and spin the red dial to the right to tighten wheel locks.

4. The brackets on the back of the ADRF-BBL/BBS-U unit can be used to secure to the wall ONLY when it is
stationed on the floor. Due to the total weight of the ADRF-BBL/BBS-U w/ batteries, it CANNOT be wall
mounted off the ground. The brackets are not designed to support the full weight of the ADRF-BBL/BBS-U
when it is wall mounted without any additional support. If a wall mounting solution is needed, then an
optional wall mount kit (ADRF-BBL/BBS-X-WMK) is available for purchase.

