ADRF PSR-78-9533-UA, Manual

Page: 18 / 60

Advanced RF Technologies, Inc. 18
Table 2-2 Terminal Block Definition
Silkscreen Label Line Type Max Supported AWG
AC_NU Neutral 12AWG
AC_R Line or Hot 12AWG
AC_G Ground 12AWG
3. OVERVIEW
3.1 LED
PSR-78-9533-UA LED indicator lights are located on the inside of the repeater towards the bottom. Below the
LED indicators is a button that is used to trigger the door open alarm.
Figure 3-1 LED Panel
Table 3-1 LED Specifications
POWER DL UL ALARM
AC Fail DL Signal Not Detected UL Out-Band Overload Power-Related Alarms
DC Fail DL Signal Low Detected UL Input Overload RF DL Path Related Alarms
Battery Fail DL RF Power UL DSP Over Input RF UL Path Related Alarms
Low Battery DL Out-Band Overload UL Over Input Over Temperature
Battery Not Charge DL Input Overload UL Over Power DSP Communication
Battery Not Connected DL DSP Over Input UL Return Power Door Open
Over Current DL Over Input UL PLL Fail System Halt
DL Over Power
DL Return Power
DL PLL Fail
LED Indicator Specifications
Solid Green Normal operation
Solid Yellow Soft Fail alarm exists in the system
Solid Red Hard Fail alarm exists in the system
3.2 Host / Remote Switch
The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of the
Ethernet port of the repeater to an alternative setup. These settings can only be adjusted by logging into the
repeater under HOST mode and configuring the settings under the Modem Box Setting section on the Install
Page (section 7.4.5).
Once the settings are set, flipping the switch to the REMOTE position will reboot the repeater with the new
alternate settings. Please note that when the repeater is set to the REMOTE position, DHCP is disabled and the
repeater will not automatically assign an IP address to any device that connects directly to the repeater.

Host IP: 192.168.63.1 (Fixed IP, unable to modify this IP address)