ADLINK Technology SMARC LEC-PX30, User Manual

Page: 35 / 57

LEC- PX30 User’s Guide SGET SMARC Rev 2.1
Page 33 copyright © 2020 ADLINK Technology Inc.
4.3.12 GPIO
Name Pin
# Description I/O
Type I/O
Level Power
Domain PU / PD Comments
GPIO0 /
CAM0_PWR# P108 General purpose I/O pin 0. I/O
CMOS 1.8V Runtime PU 470K on the
Module. Camera 0 is not supported
GPIO1 /
CAM1_PWR# P109 General purpose I/O pin 1. I/O
CMOS 1.8V Runtime PU 470K on the
Module Default use is is GPIO1 alternative use is Camera 1
Power Enable - active low, through DTS
GPIO2 /
CAM0_RST# P110 General purpose I/O pin 2. I/O
CMOS 1.8V Runtime PU 470K on the
Module Camera 0 is not supported
GPIO3 /
CAM1_RST# P111 General purpose I/O pin 3. I/O
CMOS 1.8V Runtime PU 470K on the
Module Default use is GPIO3, alternative use is Camera 1 Reset -
active low, through DTS
GPIO4 /
HDA_RST# P112 General purpose I/O pin 4. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO5 /
PWM_OUT P113 General purpose I/O pin 5. I/O
CMOS 1.8V Runtime PU 470K on the
Module Default is GPIO mode, alternate use is PWM output
GPIO6 P114 General purpose I/O pin 6. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO7 P115 General purpose I/O pin 7. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO8 P116 General purpose I/O pin 8. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO9 P117 General purpose I/O pin 9. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO10 P118 General purpose I/O pin 10. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO11 P119 General purpose I/O pin 11. I/O
CMOS 1.8V Runtime PU 470K on the
Module
GPIO12 S142 General purpose I/O pin 12 I/O
CMOS 1.8V Runtime PU 470K on the
Module advised as INT signal to I2C GPIO expander on carrier.
GPIO13 S123 General purpose I/O pin 13 I/O
CMOS 1.8V Runtime PU 470K on the
Module