ADLINK Technology PCIe-8154, User Manual, Page: 136 / 162

124
_8154_set_ltc_logic
– Set the logic of LTC signal
_8154_get_latch_data
– Get the latch data from counter
@ Description
_8154_set_trigger_logic
:
This function is used to set the logic of CMP single.
_8154_set_error_comparator
:
This function is used to set the comparing method and value
for the error comparator. When the position error counter’s
value reaches the comparing value, the 8154 will generate an
interrupt to the host PC. Also see Section B.14 on page 114.
_8154_set_general_comparator
:
This function is used to set the comparing source counter, com-
paring method and value for the general comparator. When the
comparison conditions are met, there is one of the 4 reactions
will be done. The detail setting, see the argument description.
_8154_set_trigger_comparator
:
This function is used to set the comparing source counter, com-
paring method and value for the trigger comparator. When the
comparison source counter’s value reaches the comparing
value, the 8154 will generate a pulse output via CMP and an
interrupt (event_int_status, bit 12) will also be sent to host PC.
_8154_set_latch_source
:
There are 4 latch triggering source. By using this function, user
can choose the event source to latch counters’ data.
_8154_set_ltc_logic
:
This function is used to set the logic of the latch input.
_8154_get_latch_data
:
After the latch signal arrived, the function is used to read the
latched value of counters.