ADLINK Technology PCI-8102, User Manual, Page: 110 / 210

100 MotionCreatorPro
11. Vel. Profile: Select the velocity profile. Both Trapezoidal
and S-Curve are available for “Absolute Mode,” “Relative
Mode,” and “Cont. Move.”
12.FA Speed/ATU: Sets the configurations of the FA Speed.
The related function calls are _8102_set_fa_speed().If
the check box “ATU” is checked, it will execute auto
homing when motion starts.
13.Motion Parameters: Set the parameters for single axis
motion. This parameter is meaningless if “Manual Pulser
Move” is selected, since the velocity and moving dis-
tance is decided by pulse input.
Z Start Velocity: Set the start velocity of motion in units of
PPS. In “Absolute Mode” or “Relative Mode,” only the
value is effective. For example, -100.0 is the same as
100.0. In “Cont. Move,” both the value and sign are
effective. –100.0 means 100.0 in the minus direction.
Z Maximum Velocity: Set the maximum velocity of motion
in units of PPS. In “Absolute Mode” or “Relative Mode,”
only the value is effective. For example, -5000.0 is the
same as 5000.0. In “Cont. Move,” both the value and
sing is effective. –5000.0 means 5000.0 in the minus
direction.
Z Accel. Time: Set the acceleration time in units of second.
Z Decel. Time: Set the deceleration time in units of sec-
ond.
Z SVacc: Set the S-curve range during acceleration in
units of PPS.
Z SVdec: Set the S-curve range during deceleration in
units of PPS.
Z Move Delay: This setting is effective only when repeat
mode is set “On.” It will cause the 8102 to delay for a
specified time before it continues to the next motion.