ADLINK Technology NuPRO-860 Series, User Manual

Page: 40 / 54

32 Getting Started
3.3 Heat Sink Installation
After you have finished installing the CPU and/or memory mod-
ules, replace the heat sink by replacing the four mounting screws.
Be sure that the raised blocks on the underside of the heat sink
are aligned with the CPU and northbridge on the EM-64 CPU
Module (refer to
Figure 3-6: Heat Sink Installation below).
Figure 3-6: Heat Sink Installation
3.4 Connecting IDE Devices to the NuPRO-860
The NuPRO-860 supports two IDE channels, Primary and Sec-
ondary. It has two IDE device connectors onboard supporting IDE
devices running in any data transfer mode up to ATA-100. Each
IDE connector supports two drives, a Master and a Slave. The
drives connect to the NuPRO-860 with an IDE ribbon cable.
To install an IDE drive, power down the system, connect the drive
to one of the drive connectors of a suitable ribbon cable. Plug the
board end of the cable into one of the IDE connectors on the