ADLINK Technology NEON-2000-JNX Series, User Manual

Page: 23 / 57

Connectors and I/O 13
NEON-2000-JNX
2.1.1 D-sub I/O Connector
Figure 2-3: D-sub I/O Connector
Table 2-2: D-sub I/O Connector Pin Definitions
Pin Function Pin Function
1 UART - TX 2 DI/O GND
3
Digital output 0/Strobe output 0
(see note 2)
4 Digital output 1
5 Digital output 2 6 Digital output 3
7 UART GND 8 Reserved
9 UART – RX 10 DI/O GND
11
Digital input 0/Trigger input 0
(see note 1)
12 Digital Input 1
13 Digital Input 2 14 Digital Input 3
15 Reserved
NOTE:
NOTE:
1. Pin 11 (Digital input 0/Trigger input 0) is programmable.
When configured for trigger input, it is used for hardware trig-
gering of the image sensor. Connect an external sensor signal
to pin 11 and set the camera to hardware trigger mode to
enable realtime or hardware triggered image capture.
2. Pin 3 (Digital output 0/Strobe output 0) is programmable.
When configured for strobe output, it can be connected to an
LED light/strobe controller to adjust the timing latency/delay
according to the camera connected to pin 11.
8 1
15
9