ADLINK Technology miniBASE-10R, User Manual

Page: 9 / 44

miniBASE-10R
Features
3
2. Features
2.1. Integrated Smart Battery Management System
The miniBASE-10R integrates a Smart Battery Management System that support Dual Smart Batteries and 19V
adapter. The Smart Battery Magagement System is a proof-of-concept battery power system that allows for quick
development and integration of battery power into a COM Express system.
The Smart Battery Management System use the SM Bus for communications between battery power system,
Smart Batteries and COM Express module. It is ACPI compliant and provides complete battery management under
a supporting operating system.
Note: The selected COM Express module for miniBASE-10R must support wide voltage range input. (5.7V - 14V),
even if Smart Battery power is not used.
2.2. Secondary BIOS
The miniBASE-10R supports the Serial Peripheral Interface (SPI) for COM Rev. 2.1 modules. Selection of active
BIOS can be made by jumper settings. The jumper of the secondary BIOS is JPX7.
2.3. Integrated Debug Port with Single Step Execution
In addition to a two-digit POST code display, the board also provides a four-digit address display. By jumper
selection the board can be switched into single step BIOS execution mode. Steps are executed using a manually
operated onboard mini switch.
2.4. Onboard Audio
The miniBASE-10R has a Realtek ALC262 audio codec onboard. Audio I/O is provided by a three-jack connector.
2.5. Indicator LEDs
General information is obtained through indicator LEDs for power status, drive activity, and Mini PCIe card type
(WWAN or WLAN). See 8.3 Indicator LEDs on page 34.
2.6. Power, Reset, Lid and Sleep Switches
The miniBASE-10R is equipped four mini switches (S1-4) for Reset, Power and COM.0 Rev.2.1 specified "Lid" and
"Sleep" functions.