ADLINK Technology M-302, User Manual

Page: 70 / 100

58 BIOS Setup
4.7 PnP/PCI Configurations
This section describes configuring the PCI (Personal Computer
Interconnect) bus system. PCI is a system which allows I/O
devices to operate at speeds nearing the speed the CPU itself
uses when communicating with its own components.
Init Display First
This item allows you to choose the first display interface to initiate
while booting. The choice is “PCI Slot” or “Onboard”.
Reset Configuration Data
The default is “Disabled”. Select Enabled to reset Extended Sys-
tem Configuration Data (ESCD) if you have installed a new add-on
card, and system configuration is in such a state that the OS can-
not boot.
Resource Controlled By
The commands here are “Auto(ESCD)” or “Manual”. Choosing
“Manual” requires you to choose resources from the following sub-
menu. “Auto(ESCD)” automatically configures all of the boot and
Plug and Play devices, but you must be using Windows 95 or
above.
PCI/VGA Palette Snoop
This is set to “Disabled” by default.