ADLINK Technology IMB-T10, User Manual

Page: 43 / 70

BIOS Setup 31
IMB-T10
4 BIOS Setup
4.1 Introduction
This section explains how to use the UEFI SETUP UTILITY to
configure your system. The UEFI chip on the motherboard stores
the UEFI SETUP UTILITY. You may run the UEFI SETUP UTILITY
when you start the computer. Please press <F2> or <Del> during
the Power-On-Self-Test (POST) to enter the UEFI SETUP UTIL-
ITY, otherwise POST will continue with its test routines.
If you wish to enter the UEFI SETUP UTILITY after POST, restart
the system by pressing <Ctl> + <Alt> + <Delete>, or by pressing
the reset button on the system chassis. You may also restart by
turning the system off and then back on.
4.1.1 UEFI Menu Bar
The top of the screen has a menu bar with the following selec-
tions:
Main : To set up the system time/date information
Advanced : To set up the advanced UEFI features
H/W Monitor : To display current hardware status
Boot : To set up the default system device to locate and load the
Operating System
Security : To set up the security features
Exit : To exit the current screen or the UEFI SETUP UTILITY
Use <
←
> key or <
→
> key to choose between the selections on
the menu bar, and then press <Enter> to get into the sub screen.
You can also use the mouse to choose your required item by click-
ing.
NOTE: NOTE:
Because the UEFI software is constantly being updated, the
following UEFI setup screens and descriptions are for refer-
ence purpose only, and they may not exactly match what you
see on your screen.