
54
DirectShow Programming Guide
3.1.2
Example Graphs
The Microsoft DirectX SDK provides the GraphEdit debugging util-
ity, which can simulate graph building. Desired filters can be cho-
sen from the the Insert Filters command of the Graph menu.
Filters are organized by categories. Insert Filter adds the filters to
a graph, and two filters’ pins can be selected by dragging from one
NOTE:
NOTE:
Video RGB In is an analog RGB signal from DVI-I connector
Video YRYBY In is an YPbPr signal from the I/O bracket
connector
Video SerialDigital In is a HDMI signal from DVI-I connector
Video Composite In is a standard NTSC/PAL signal from I/O
bracket
Video SVideo In is a standard NTSC/PAL signal from I/O
bracket
1
st
Audio SPDIF In is a audio packet embedded into HDMI
input
2
nd
Audio SPDIF In is a SPDIF audio signal from Toslink
connector
3
rd
Audio SPDIF In is a SPDIF audio signal from RCA
connector
Calling IAMCrossbar::Route switches the input channel
Summary of Contents for HDV62A
