ADLINK Technology EVA SDK, User Manual, Page: 9 / 117

EVA SDK User's Manual
Setting Environment Variables
5
2 Setting Environment Variables
Before using EVA SDK, the environment must be installed and set up. For installation details, refer to the EVA
Installation Guide.
On Linux (include x86 and ARM), after installing EVA SDK and required software, open a terminal and run the
following command to set the environment variables.
$ source /opt/adlink/eva/scripts/setup_eva_envs.sh
If you have changed the install path (INSTALL_DIR), be sure to specify the path.
$ source INSTALL_DIR/scripts/setup_eva_envs.sh
The script will set up the environment variables of the following installed software.
•
OpenVINO
•
MediaSDK
•
Pylon
•
ADLINK EVA SDK
If the software has no corresponding libraries, the script will not set up the corresponding environment variables.
Note : The environment variables are removed when closing the terminal.
On Windows, after installing EVA SDK and required software, there are two ways to execute the EVA IDE.
Method 1: Manually run the environment variable settings.
Open a Windows command prompt and then run the following commands to set the environment variables; then
enter the GStreamer command or your application to execute.
> C:\ADLINK\gstreamer\setupvars.bat
> C:\ADLINK\eva\scripts\setup_eva_envs.bat
Note : The environment variables are removed when closing the command prompt.
Method 2 : Run the desktop shortcut.
On Windows, run EVACMD on the desktop. The shortcut will automatically set the environment and open the
command prompt. You can then enter the GStreamer command.