8
Getting Started
Figure 2-1: cPCIS-3330 Series slot layout
The handles on CompactPCI cards and PSUs ensure simple and
safe installation and removal. Please follow the procedures below
to install a CompactPCI module into a chassis:
CompactPCI Card Installation/Removal Procedure
1. Place the sub-system on a level surface or rackmount it.
Remove the blanking plates where required by undoing
the retaining screws at each end. Retain the blanking
plates for possible future use. The system should not be
put into use without blanking plates covering all empty
slots, otherwise the EMC and cooling performance will
be compromised
2. Hold the system board or peripheral card module verti-
cally. Make sure that the handles are unlatched (i.e. that
Summary of Contents for cPCIS-3330 Series
