ADLINK Technology cPCI-6210 Series, User Manual, Page: 60 / 140

46 Board Interfaces
4.5 Switch and Jumper Settings
Refer to “cPCI-6210(D) Series Board Layout” on page 23 for
switch locations.
Load BIOS Default Switch (SW2)
Press switch SW2 to load the default BIOS settings.
Front/Rear VGA/LAN Selection Switch (SW3)
Switch SW3 sets the VGA and LAN3 outputs to the front panel
or to the rear panel of the RTM. The default VGA and LAN3
outputs are set to the front panel.
Table 4-23: Front/Rear VGA Selection Switch Settings
SW5 & SW7 (Debug use only)
The switches SW5 & SW7 are for debugging purposes and
should be left in the default settings. The default setting of SW5
is all OFF; the default setting of SW7 is Pin 1 OFF and Pin 2
ON.
Switch Pin 1 Mode
1
ON Rear VGA output
OFF Front VGA output
2
ON Front LAN3 output
OFF Rear LAN3 output
ON
1
2
3
ON
1 2