ADLINK Technology AdvancedMC AMC-8100, User Manual

Page: 49 / 76

BIOS Features 35
AMC-8100
If the FC devices on your IntraServer adapter are not identified by
your system, check the following:
X
Is the FC enclosure powered ON?
X
Does the LED on the adapter indicate Link? (Note that Link
is valid only after the device is probed.)
X
Does the LED on the switch or remote enclosure indicate
Link?
X
Does the Link-SPEED parameter selected by the adapter
match that of the bus (1G, 2G, or Auto)?
If you do not see disks, the following additional debug information
may help to identify the problem.
5.5.3 Verifying Installation
Use the following procedure to verify installation of your
Fusion-MPT adapter in the system:
1. Power-up the system.
2. When the banner is displayed, press the Stop-A keys to
interrupt the boot process and stop at the ok prompt.
3. Use the show-devs command to list the system devices.
You should see an output similar to the following:
ok show-devs
/SUNW,UltraSPARC-III@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages
/upa@8,480000/SUNW,ffb@0,0
...
/pci@8,700000/IntraServer,fc@2
/pci@8,700000/IntraServer,fc@1,1
/pci@8,700000/IntraServer,fc@1
/pci@8,700000/IntraServer,fc@2/disk
/pci@8,700000/IntraServer,fc@2/tape