ADLINK Technology AdvancedMC AMC-8100, User Manual

Page: 33 / 76

Fibre Channel Firmware Installation 19
AMC-8100
6. When prompted, type the firmware file name.
7. Type Yes, when asked to continue (see figure below).
Figure 4-3: LSIUtil File Download
The update process requires about 20–30 seconds. Upon com-
pletion, the system should display this message: download
succeeded.
8. Reset the adapter using option
99
, or reboot to begin
running the new firmware.
9. Enter
0
to quit the program.
Command Line Update Tool for DOS
Using a DOS bootable floppy, users can use a FC Flash Utility
called MPTUtil to update LSI adapters with new firmware (see
Downloading New FC Firmware on page 16). This section pro-
vides the procedure for operating this program.
Running the MPTUtil Program
Use the MPTUtil program to update the FC firmware on any 4
Gbit/s host adapter. Locate the MPTUtil.exe program and
FC949X.ROM code on your distribution media, as well as the
DOS4GW.exe file. Copy these files to a blank, formatted dis-
kette. Label it “FC Firmware diskette.”
To update the firmware, complete the following steps:
1. Ensure that the host adapter is properly installed in the
system PCI slot.
2. Insert the LSI FC firmware diskette into drive A:.
NOTE: NOTE:
The MPTUtil program will not operate properly from a windows
command window. It must be run from a DOS floppy.