Sidewinder X1 Belt Kit assembly manual
P a g e
27 | 30
Bed leveling:
After tensioning belt, use a large metal ruler or a level, and place it over
the belt, while supporting the ruler over the rollers, use the leveling nuts to adjust any
misalignment, repeat the process on both sides.
Figure 33 leveling bed left side
Figure 34 leveling bed right side
45° Axis endstop Regulation:
loosen diagonal endstop support, get X axis down to bed,
place a piece of paper between nozzle and belt, then push endstop back to X axis until
switch is pressed down finally adjust endstop support. Fine tune the position of the
endstop if the nozzle is too high or down.
Chapter 9
Slicer settings
We recommend to Use BLACKBELT Cura as slicer, but there are some other slicers
available as well.