Adisa NEO FIRE 120, Technical Manual Of Installation, Use And Maintenance

Page: 38 / 77

NEO FIRE – Technical Manual
38
12.1 Heating circuits basic parameters
Activation of heating circuits
Heating circuits are deactivated in default parametrization (heat demand of the boiler is given by the
parameter 1859 “Flow temp setp cons request”). Adjust the following parameters to enable the heating
circuits and to assign the extension modules to each heating circuit.
12.2 Professional installator parameters
Operating mode
The operating modes of the heating circuits are selected directly in the temperature page.
This setting is used to switch between different operating modes which are:
Automatic
The living zone is operated as per the time switch program
Automatic energy savings functions (e.g. summer/winter mode)
Temporarily 'warmer' or 'cooler' allows the user to temporarily adjust the temperature for special situations
Adjust comfort setpoint
Protective functions active
Protection
The living zone remains protected (frost protection, protection against heat accumulation)
The living zone is switch off
Protective functions active
Automatic summer/winter changeover (ECO functions) and automatic 24-hour heating limit active
Reduced
The living zone is operated continuously at a reduced setpoint
Protective functions active
Automatic summer/winter changeover (ECO functions) and automatic 24-hour heating limit active
Comfort
The living zone is operated continuously at the comfort setpoint
Protective functions active
Automatic summer/winter changeover (ECO functions) and automatic 24-hour heating limit active
Heating curve slope
The heating curve generates the flow temperature setpoint, which is used to maintain a certain flow
temperature level depending on the prevailing weather conditions.