OPERATING AND USER MANUAL Q-12 CoaXPress series
________________________________________________________________________________________________________________
_________________________________________________________________________________________
Adimec
28
For 2x2 binning, the ProgrammableGainAmplifier and SensorBitDepth features are not available. In
binned mode the PGA gain is set to 1 and the sensor bit depth to 10 bit.
Separate DF_ and BF_ column calibrations are available for sensor binning for both average and
summed binning modes.
Binning and frame rate
For 2x2 sensor binning the maximum frame rate in full ROI will increase to 267.4 fps. This maximum
frame rate does not depend on the sensor bit depth or the interface bit depth.
(StreamPacketSizeMax=4096, ConnectionConfig=CXP6_X4, InterfaceUtilization=100)
Binning and defect pixel behavior
From factory the defect pixel list is created in non-binned mode. It might occur that in 2x2 sensor binning
mode defect binned pixels show up while none of the physical pixels inside the bin is defect in non-
binned mode. These binned defect pixels need to be added manually to the defect pixel list.
A binned pixel can be marked defect by marking one of the pixels inside the bin as defect. So for 2x2
binning the following coordinate transformation can be used to mark a binned pixel defect:
Y
non-binned
= 2Y
binned
, X
non-binned
= 2X
binned
, (top left pixel has coordinates 0,0)
7.5.7 BinningHorizontal |
RW
|
E |
ISSUE 2 ONLY
1 or 2
Set the number of horizontal pixels to combine together. This reduces the
horizontal width of the image. A value of 1 indicates that no horizontal
binning is performed by the camera.
7.5.8 BinningVertical |
RW
|
E |
ISSUE 2 ONLY
1 or 2
Set the number of vertical pixels to combine together. This reduces the
vertical height of the image. A value of 1 indicates that no vertical binning is
performed by the camera.
7.5.9 BinningMode |
RW
|
B |
ISSUE 2 ONLY
Sum
Set the binned pixel signal level to the sum of the signal levels of the
individual pixels of which it is composed.
Average
Set the binned pixel signal level to the average of the signal levels of the
individual pixels of which it is composed.
7.5.10 ReverseX
| RW | E |
True
The output image is flipped horizontally. For a color camera, the pixel
format is updated automatically to reflect the correct Bayer phase. The
Region of interest is applied after the flipping.
False
The output image is not flipped.
