Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
EnOcean / NMEA2000
Document code: MN67C73_ENG Revision 1.000 Page 23 of 30
SEND FRAMES:
By pressing the “
Send Frames
” button from the main window for SW67C73 (Fig. 2) the “Send NMEA2000 frames” window appears (Fig. 8).
The COB inserted in this table contains the data received from EnOcean side. These frames are sent by the converter.
The data of the columns have the following meanings:
If the field “
Enable
” is checked, the NMEA2000
frame is enabled;
In the field “
Cob-ID
” the COB of the NMEA2000
frame is defined;
In the field “
Type
” the type of NMEA2000
packet use for this Cob-ID is defined (2.0A (11 bits) or 2.0B (29 bits));
In the field “
Dimension
” the number of byte of the COB (from 1 to 8) is defined;
If the field “
OnChange
” is checked, the frame is sent when the data from EnOcean change;
If the field “
OnCMD
” is checked, the frame is sent when a EnOcean message is received;
If the field “
OnTimer
” is checked, the frame is sent cyclically with the delay defined in the field “
Time
” (expressed in ms);
In the field “
Byte1
” insert the byte of the internal array where taking 1st byte of the NMEA2000
message;
In the field “
Byte2
” insert the byte of the internal array where taking 2nd byte of the NMEA2000
message;
In the field “
Byte3
” insert the byte of the internal array where taking 3rd byte of the NMEA2000
message;
In the field “
Byte4
” insert the byte of the internal array where taking 4th byte of the NMEA2000
message;
In the field “
Byte5
” insert the byte of the internal array where taking 5th byte of the NMEA2000
message;
Figure 8: “Transmit NMEA2000 Frames Set Access” window