ADF Web HD67832-IP-B2, User Manual

Page: 21 / 42

Industrial Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO: www.adfweb.com Phone +39.0438.30.91.31
User Manual DALI / BACnet Master - Converter
Document code: MN67832_ENG Revision 1.000 Pagina 21 di 42
S
ET
A
CCESS
The “ Set Access ” section (Fig. 4b) is used to list the DALI sensors to read and the DALI commands to send to the DALI ballasts. The means
of the fields are:
If the field “ Enable ” is checked, the DALI device/sensor is enabled;
In the field “ Dev/Sen ” the DALI node is defined;
In the field “ Type ” the type of DALI node to read/write is defined;
In the field “ Ch. Number ” the ID of the DALI node is defined;
In the field “ Instance ” the instance of the DALI node is defined;
In the field “ Command ” the command code to send is defined. If not used, this column can be set to ‘0’;
In the field “ Time Send ” the delay in ms between the commands is defined. If not used, this column can be set to ‘0’;
In the field “ Timeout ” the timeout in ms for the reception of the response is defined. If not used, this column can be set to ‘0’;
In the field “ Function ” the DALI function to recall is define. This feature is used to control DALI ballasts automatically from a DALI 2
device as a DALI router;
In the field “ Position ” the byte of the internal memory array where mapping the data is defined;
In the field “ Num Bytes ” the dimension of the data is defined;
In the field “ Mnemonic ” a description of the row is defined.
Note:
This table is not required if the HD67832-B2 is used to communicate with DALI 1 devices only.
Figure 4b: “Set Access” window