Adeunis RF Sigfox MOTION V2, User Manual, Page: 40 / 46

EN
Sigfox MOTION V2 - Guide utilisateur / User guide version V2.0.1
40 Page of 46
FR
2.1.5.01 Periodic sending with or without history logs
The device allows the measurement and the periodic sending of the sensor values according to the following diagram:
The device makes it possible to record luminosity and the occupancy rates at a certain frequency, to store this information and then to send it
periodically.
The occupancy rate correspond to the time where the room was occupied on the total time of
the period (in %).
The parameters associated with this operating mode are:
•
Period of acquisition (S321)
• Backup period (S320)
• Period of transmission(S301)
E.g.:
Register Value
encoding
Value Result
S321 Decimal 5400
1 reading every 3 hours 5400 * 2sec
= 10800 sec = 3 hours
S320 Decimal 1 1 backup at each reading
S301 Decimal 2
Periodic mode with a period of 2
backup (2 * 3 hours) = every 6
hours
S330 Decimal 0 Presence alarm off
S340 Decimal 0 Luminosity alarm off
In this example:
• The device takes the luminosity every 2 hours and measures the occupancy on this period,
and saves the information
• The device will make 2 backups and send them 4 times per day
• The device is in pure periodic sending mode since the alarms have been disabled.
Be careful about backup and sending values that will also depend on the network used and its
bandwidth.
Note: for a transmission without history, it is sufficient to set the register 301 (transmission
period) to 1 so the device will send a frame to each backup.
Product in standby
Send frame 0x5C
Backup
Measure luminosity &
occupancy rates
Number
of readings
reached
?
Period
of acquisition
reached?
Number of
backups
reached?