EN
Sigfox MOTION V2 - Guide utilisateur / User guide version V2.0.1
36
Page
of 46
FR
2. DEVICE OPERATION
2.1. Operating modes
IMPORTANT NOTE:
adeunis® uses the Big-Endian data format
The device has several operating modes
2.1.1 PARK MODE
The device is delivered in PARK mode, it is thus in standby mode and its consumption is minimal. Exit PARK mode by pressing and holding the
button for more than 5 seconds. The green LED lights up to indicate the detection of the pressed button and then flashes rapidly during the
device start-up phase.
The device then sends its configuration and data frames.
2.1.2 COMMAND MODE
This mode is used to configure the device registers. There are two ways to enter this mode:
-
Open the adeunis® IoT Configurator application, connect a cable to the device’s micro-USB port and connect it to the computer or
mobile phone.
-
Connect a cable to the micro-USB port of the device and enter command mode via an AT command.
The output of the COMMAND mode is via the ATO command or the USB cable disconnection. The device will then return to its previous mode,
i.e. PARK or OPERATING
2.1.3 OPERATING MODE
This mode allows the device to work in its intended end use.
2.1.4 Low battery management
When the product detect that the battery is not able to deliver the level of power required for a emission (extreme temperature or end-of-life of
the battery), it waits to be able to transmit. If it detect that the generated delay is longer than 1 minute, it informs the user activating the “low
battery” flag in the status byte of each frame sent.
MODE PARC
MODE EXPLOITATION
SHUT-DOWN
(no battery)
MODE COMMANDE
Battery replaced
Command send-
ing by serial link
Long press on the
button >5s
Information sent if
battery low
Auto adaptation
(cf Low battery
management)
The “battery low” flag is automatically disappearing when the battery is replaced or when temperature conditions are favorable to the proper
functioning of the battery.
The product have
to sent a frame
Product wait
to be able to
transmit
The product
send the frame
Delay lower
than 1 minute
?
“low battery”
appeared in
status byte
Enough pow-
er to send a
frame ?
yes
yes
no
no
no
no
Summary of Contents for Sigfox MOTION V2
Page 5: ...FR Sigfox MOTION V2 Guide utilisateur User guide version V2 0 1 5 Page of 46 FR FRAN AIS...
Page 7: ...FR Sigfox MOTION V2 Guide utilisateur User guide version V2 0 1 7 Page of 46 FR...
Page 26: ...EN Sigfox MOTION V2 Guide utilisateur User guide version V2 0 1 26 Page of 46 FR ENGLISH...
Page 28: ...EN Sigfox MOTION V2 Guide utilisateur User guide version V2 0 1 28 Page of 46 FR...