Page 8
Manual SVA alarm dialler | Back to
Adesys B.V. | Wateringen
3.4.1.
Input delay
A delay can be set for the status notification (active and idle message) in input delay. This means the
status notification will not be sent until the input has been activated or deactivated for longer than this
period. The maximum that can be set is ‘3600’ seconds.
If an input goes back into idle mode during the delay time, the notification procedure does not start.
3.4.2. Recovery report (idle)
If desired, a recovery report SMS can be sent after the input goes into idle mode. The default setting is off
even if nothing has been selected. Select ‘Yes’ to activate this notification. A recovery report will always be
sent to the external server.
3.4.3. System errors
Various system errors can be detected by the SVA. Notifications can be set up individually for each error.
Depending upon the error, this is displayed in the programming tool and a notification is sent via SMS. By
default the notification of all system errors via SMS is switched off.
3.5. Connections
The term ‘connections’ is used to mean the connection to an external server. With the SVA it is possible to
make a connection to Checkmyproces.com or to a dedicated server.
3.5.1. Checkmyproces.com
Checkmyproces is a server on which the status is displayed via the cloud. After logging in, diallers can
be connected to the account. This connection takes place via the IMEI number. The IMEI number can be
obtained via SV-prog in the status screen and by looking on the side of de dialler.
Remote configuration
It is possible to remotely make changes to the settings of the dialler. This is possible by ethernet and by
4G/GPRS. For using remote configuration it is necessary to have a constant connection. When using 4G/
GPRS keep in mind of the extra cost.
If the network is secured by use of a firewall. Please make the following exceptions.
Data connection
URL
:
http://svx.meetcentrale.nl:80/severa
Protocol :
http
Port
:
80
System Settings
URL
:
Protocol :
mqtt
Port
:
1883
3.5.2. Own server
this IP address. The connection to your own server is made via two paths. The message is sent via HTTP
POST and the settings via MQTT. For more information please contact Adésys.
3.6. System
In the system section you can change the general SVA settings, enter GSM and mobile data settings or
trigger a factory reset.
3.6.1.
Device
In this window you can change device-specific settings such as device name, alarm active text, alarm
recovery text, automatic updates, periodic reset and a periodic report.
3.6.2. Ethernet
Ethernet can be set up with a DHCP server or with the IP, DNS and gateway entered by the user. When an
error occurs it is possible to reset the DHCP by pushing the reset key for a duration of 3 seconds, releasing
it 3 seconds and doing this 3 times. After which the leds wil show restart sequence.
3.6.3.
GSM and mobile data
Here, the GSM module can be switched off, the PIN code entered, 2G/4G mobile data switched off and
locked. You here also will find APN set up. Please contact your provider for the APN settings.
