ADEMCO Galant 6128 RFH, User Instructions, Page: 5 / 12

NIGHT SET
Night Set permits the user to set the system in selected areas, whilst
others are unset, e.g. unset in bedrooms whilst set in remaining rooms
of house. This permits freedom of movement in the secure environment.
To
NIGHT SET the system:
1. Enter the User Code.
2. Press 3/Night.
During the exit period, the “STAY” symbol will be displayed. Two
confirmation beeps indicate that the system has set.
Note:
To stop the system from setting during the exit period press
¸
. When the system has set,
¸
will no longer function.
Press # + 3/Night to EASY SET the system, if available
.
Unsetting the System
To
UNSET
the system:
1. Proceed to a keypad via the approved route and enter the
User Code.
Resetting the System
To
UNSET and RESET the system during or after an alarm:
Entering a User Code will stop any alarm in progress. The zone number
causing the initial alarm will then be displayed on the LCD. The User
Code may be entered again to RESET the system.
If the panel has been programmed to accept only an Engineer Reset
after an alarm an Engineer Code is required to RESET the system.
If the panel has been programmed to accept only a Technistore Reset
the keypad will flash the
CE symbol followed by the activated zone
number. The CE symbol will then flash again followed by a five-digit
code which should be given to the monitoring station who will then issue
an anticode. This anticode will RESET the system when entered on the
keypad.
Note:
If the system does not reset contact the engineer or alarm
company.
5