AddSecure Tor V, PDK-11606
18
APPENDIX – INSTRUCTIONS FOR MEASURING THE SIGNAL STRENGTH ON
A COMPUTER
These instructions describe a general configuration for measuring the GSM signal strength on a
computer. The measurement is only available before the alarm transmitter is commissioned;
afterward, this function is turned off.
Requirements
To measure signal strength, you need:
Computer with a browser
Crossover Ethernet RJ45 TP
network cable
Instructions
Here are only the details necessary to
measure signal strength in your web
browser.
1.
Configure your computer for DHCP (you automatically get an IP address between
172.20.20.20 and 172.20.20.250).
2.
Connect the computer to ETH 1 in the Tor V with a crossover network cable
(Ethernet RJ45 TP).
3.
Connect to this address using your browser: http://172.20.20.1:3080
You now see a number between 0 and 31. The number corresponds to the signal strength that
the alarm transmitter currently has. The page is updated continuously.
If you need help configuring the computer, please turn to the IT department at your company
and give them these instructions.
