Addonics
T E C H N O L O G I E S
Ruby Combo Hard Drive
RCHDSAES & RCHDSAEU
User’s Guide
Version 1.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Enclosure Overview
Step 1
Separate the top from the bottom cover of the drive enclosure by
loosening the screw as shown on the photo.
Step 2
Align the SATA connector in the 2.5” hard drive with the SATA connector
on the PCB.
Step 3
Wrap the shock absorbers around the hard drive and PCB.
shock
absorbers
PCB
top cover
2.5” SATA
hard drive
bottom cover
switch
