www.adder.com
www
.adde
r.co
m
CCS-X
B
CCS-XB
Quick Start
Self adhesive
rubber feet
CCS-XB controller
Four LED monitor indicators
Adder P/N: CCS-LED
(Also available separately when
more than four are required)
CATx link cable
Adder P/N: VSC46
What’s in the box
Connection overview inside
Full user guide available at
www.adder.com
© 2019 Adder Technology Limited • All trademarks are acknowledged.
Part No. MAN-CCS-XB-QS • Release 2.1
The CCS-XB module works together with either the Adder CCS4-USB or CCS-PRO4 switches to provide LED
indicators for each of your video display screens. As the switch activates a screen, the CCS-XB module activates
the corresponding indicator (which can be attached to the screen) to provide extra clarity for the operator.
Checking the firmware version (CCS4-USB switches only)
When using the CCS-XB module with a CCS4-USB switch, it is important that the switch has firmware version
2.0 (or greater) installed. If in doubt you can check the firmware version of your CCS4-USB switch as follows:
1 With your CCS4-USB switch powered on and with a USB keyboard attached, press and hold the
COMPUTER button for roughly six seconds until the display shows
C
.
2 On the connected keyboard, press
F
followed by
1
and then press
Enter
. The digits of the firmware
version will be shown in sequence with a short pause between each. For instance,
1
>
0
>
2
means that
the firmware version is
1.02
and requires an upgrade.
3 Press
E
and then press
Enter
to return the CCS4-USB to normal operation.
If your CCS4-USB switch does require a firmware upgrade, please refer to the
Performing upgrades
section of the CCS4-USB user guide.
Part numbers
CCS-XB
Controller with CATx link cable and 4 LED monitor indicators
CCS-XB0
Controller with CATx link cable
CCS-XB8
Controller with CATx link cable and 8 LED monitor indicators
CCS-LED
LED monitor indicator with 3m cable
CCS-LED-5M
LED monitor indicator with 5m cable
