14
INST
ALLA
TION
Transmitter
power connection
There is no on/off switch on either of the
AdderLink XD modules, so operation
begins as soon as power is applied. The
power adapters supplied with the modules
use locking-type plugs to help prevent
accidental disconnections; please follow the
instructions shown on the right whenever
disconnecting a power adapter.
To connect the power adapter
1 Attach the output plug of the supplied power adapter to the
power input socket on the right side of the rear panel.
2
Connect the IEC connector of the supplied country-specific power cord to the socket
of the power adapter.
3 Connect the power cord to a nearby mains supply socket.
To disconnect the power adapter
1 Isolate the power adapter from the mains supply.
2 Grasp the outer body of the power adapter plug
where it connects with the module.
3 Gently pull the body of the outer plug away from
the module. As the body of the plug slides back,
it will release from the socket and you can fully
withdraw the whole plug.
IMPORTANT: Please read and adhere to the electrical safety information
given within the supplied safety leaflet. In particular, do not use an
unearthed power socket or extension cable.
Note: Both the modules and the power supplies generate heat when in operation and will
become warm to the touch. Do not enclose them or place them in locations where air cannot
circulate to cool the equipment. Do not operate the equipment in ambient temperatures
exceeding 40 degrees Centigrade. Do not place the products in contact with equipment whose
surface temperature exceeds 40 degrees Centigrade.
From the
power adapter
Gently pull back the plug outer
body to release the lock
RECEIVER
LINK
POWER
IN
VIDEO
LINK(S)
USB
LINK(S)
AUDIO
LINKS
TRANSMITTER
REMOTE
PORT
12
VD
C
12
VD
C
