20
FUR
THER
INFORMA
TION
General Information
Device Type
- States whether the device is a transmitter (TX) or a
receiver (RX).
Device Name
- Name details that you can alter to distinguish this unit
from all others. Not shown when operating under AIM server control.
Device Description
- Allows you to optionally add a description of the
device. Useful when many ALIF units are being used. Not shown when
operating under AIM server control.
Device Location
- Allows you to optionally add a description of the
device’s location. Useful when many ALIF units are being used. Not
shown when operating under AIM server control.
Current Software Version
- Displays the version number of the
currently installed (and active) internal software.
Serial Number
- Displays the fixed serial number of the device.
Board Revision
- Displays the revision number of the device’s main
circuit board.
RX - General Information
To get here
You can access this page in two ways:
1 On the console keyboard attached to the RX unit, access
the OSD by pressing
CTRL + ALT + C
.
2 If necessary, click the
General Information
link.
OR
1 Connect a computer to the same network as the RX unit.
2 Run a web browser and enter the IP address of the RX
unit:
http://169.254.1.32
(this is the default address when
using SFP port 3). If you are using SFP port 4 then the
default address will be
http://169.254.1.42
If the IP address is unknown, press the small button on the
front panel next to the OLED screen to reveal the value
for
IP Address 3
(or IP Address 4)
and use that address.
3 If necessary, click the
General Information
link.
Device Model
- Displays the model number of the device.
Date and Time
- Displays the current date and time used by the device
when this page was last loaded (select refresh icon to update).
Uptime
- Shows the time period for which the device has currently
being running since the last time this page was loaded (select refresh
icon to update).
Identify Device
- When clicked, this button will cause the indicator on
the front panel of the device to flash to assist with identification when
multiple units are installed in the same area. A popup dialog will also be
displayed on screen showing all relevant identification details. Click the
Cancel button to stop the identification process or click the OK button
to close the popup (and then click the Identify Device button when
you’re ready to cancel this operation).