ADDER ADDERLink INFINITY 101T-DVI, User Manual, Page: 9 / 40

8
INST
ALLA
TION
CONFIGURA
TION
OPERA
TION
FUR
THER
INFORMA
TION
INDEX
ADDERLink INFINITY browser-based configuration utility
The browser-based configuration utility within all TX and RX units requires a network
connection between the ALIF101T unit and a computer on the same network. The
configuration utility allows you to perform many important functions. Please see
Appendix B .
To connect a computer to access the configuration utility
1 Connect a CAT 5, 5e, 6, or 7 link cable to the network port on the front panel.
The port automatically configures itself, so no cross-over cable is required (but is
supported if you do use one).
2 Connect the other end of the link cable directly to the network port of your
computer.
To access the browser-based configuration utility
1 Temporarily connect the ALIF101T unit and your computer, as discussed left.
2 Run a web browser on your computer and enter the IP address of the ALIF101T unit:
169.254.1.33
Note: If the IP address of ALIF101T unit has been changed and is not known, providing it is
appropriate to do so, perform a manual factory reset to restore the default address.
The opening page of the ALIF configuration utility should be displayed:
Use the menu options to choose
the required configuration page
Temporary link
from your computer
to the ALIF101T
network port
You can find further information about the configuration pages later in this guide:
• Appendix B - Configuration pages