8230E Optical Power Meter Operation Manual
3.4.2 How to Initialize
3-5
Figure 3-1 Outline of the Parameter Backup
3.4.2
How to Initialize
1. How to initialize all parameters to the factory set values.
•
Press the
[POWER]
key while pressing the
[W/dBm]
key and turn on the power.
•
“F INIT” is displayed and all parameters are initialized to the factory set values.
2. How to initialize parameters, excluding MYID.
•
Press
[MENU]
and
[PREV]/[NEXT]
to select “Parameter load”.
•
Select DFLT by using the
[UP
]/[DOWN
]
key.
•
Press the
[ENTER]
key. “DONE” is displayed, the menu exits, and the parameters excluding
MYID are initialized.
By following the above operation, the settings, which are backed up by the battery, and the settings, which
are saved in the built-in flash memory, are initialized.
Volatile memory
Parameters which are backed
up
Parameters which are not
backed up
Save/Load
Nonvolatile flash memory
USER-0 area
USER-1 area
USER-2 area
USER-3 area
If the setting parameters were cleared,
load when the power is turned on.
(For software revision C00 or later)
