8230E Optical Power Meter Operation Manual
3. HOW TO PERFORM MEASUREMENTS
3-1
3.
HOW TO PERFORM MEASUREMENTS
3.1
Menu Map
NOTE:
1.
If, after changing each item's setting, the PREV/NEXT key is used to move to the next item, the setting is not
saved. Each setting is saved only when the ENTER key is pressed.
*1
Saves the new settings
and closes the menu.
Cancels the new settings
and closes the menu.
1 Number of
smoothing times
3 CF value
4 Calibration
wavelength
6 Auto power off
7 Parameter save
8 Parameter load
9 Wavelength
Preset *3
Blinking (cursor)
Blinking (cursor)
Blinking (cursor)
Blinking (cursor)
Blinking (cursor)
Blinking (cursor)
2 CF
10 CAL
11 MYID
Blinking (cursor)
Blinking (cursor)
*1
*1 The settings are saved or loaded by pressing the
[ENTER]
key and “DONE” is displayed at the end.
*2 For more information, refer to 3.5, “Wavelength Preset.”
*3 Wavelength preset
function is applied to the software revision B00 or later.
*4 If
[HOLD]
is pressed, the calibration value for each
calibration wavelength is displayed for approximately two
seconds.
Blinking (cursor)
5 Number of
display digits
(C00 or later)
*1
*2
*4