4601 I-V Meter Operation Manual
1.8 Cleaning, Storage, and Transport Methods
1-18
5. Pressing
(the backlight goes ON) outputs the displayed source value
and starts measurement.
Figure 1-10 Display during OPERATE
6. Pressing
again (the backlight goes OFF) turns off the output and stops
measurement.
NOTE:
1.
The 4601 starts up with the initial values that are preset before shipment when it
is turned on for the first time.
When the setting parameter condition at Power ON is changed, the screen display
may be different from Figure 1-8.
For more information, refer to Section 3.6.3, “Auto Parameter Loading at Power
ON.”
When turning on the output for the first time, pay attention to source value setting
and load connection.
2.
If a problem occurs during the self-test, an error message will appear on the
screen.
Refer to Section A.2, “Error Message List.”
1.8
Cleaning, Storage, and Transport Methods
1.8.1
Cleaning
Clean the 4601 by wiping or brushing its surface with a soft cloth or cloth which has been dampened in
water containing a mild detergent.
CAUTION:
1.
Ensure that water does not penetrate the 4601 (wring out the cloth so it is damp and not saturated).
2.
Avoid using organic solvents such as benzene, toluene, xylene, acetone, etc. They will cause deformation of
the plastic parts.
1.8.2
Storage
Store the 4601 in a location where the temperature is within the range of -25
C to +70
C. If storing for
an extended period (90 days or longer), place the 4601 in a moisture-proof bag together with a desiccant.
Avoid storing the 4601 in a location where there is a lot of dust or where it will be subjected to direct
sunlight.
