ADC Soneplex Soneplex Fiber Hub Cabinet SPX-CABFIN04, User Manual

Page: 45 / 84

LTPS-UM-8007-01, Issue 1 Installation
SPX-CABFIN01, SPX-CABFIN04 November 9, 2001 33
21 Connect the cables to the remaining batteries (Step 14 through Step 20), and install the batteries in the
sequence of
Figure 27 on page 34 .
22 Route the battery cable to the cable aisle (space between battery rows), starting from the midpoint of the short
side of each battery.
Figure 26. Battery Cable Installation of Screw Terminal
23 Plug the connector into the battery connector bus at the front of the drawer at the numbered positions shown
in
Figure 27 on page 34 or Figure 28 on page 34 .
For ease in connecting the battery cables (and TSUs) later, place all batteries in the same
position as the first battery (negative terminals nearest the center of the battery drawer).
Loop the cable from the negative terminal (nearest the cable aisle) against the connector bus as
shown in
Figure 27 on page 34 . Route the cable from the positive terminal straight across the
battery.
For each battery position, use the corresponding cable number and battery bus connector
number.
For 12V batteries, connect the first and last batteries in string 1 to connectors 1 and 4,
respectively. Connect the first and last batteries in string 2 to connectors 5 and 8, respectively.