Installation
LTPS-UM-8007-01, Issue 1
30
November 9, 2001
SPX-CABFIN01, SPX-CABFIN04
Figure 23.
Calibration Voltage Label Location
9
Attach the temperature compensation module to the battery, using the long cable ties supplied as shown in
. Place the module low on the front of the battery, so that it will fit under the battery
connector bus. Tighten the cable ties securely, and verify that the module is held firmly in place. Trim any
excess cable tie.
10
Push the battery with the temperature compensation module into its installed position
Connect the plug-ended leads from the module to the mating plug on the sense leads in the battery drawer.
11
Locate the plug-ended battery cable kit (furnished in a loose parts package).
Each cable assembly has a battery bus connector and positive and negative leads; the positive
(+) lead is marked on each cable.
Battery drawers are shipped with battery cables cut to four different lengths. Select the longest
cables for the batteries at the back of the drawer (positions 2 and 5).
Calibration
voltage
label
