ADC RF Worx RDS-2, User Manual, Page: 25 / 45

ADCP-61-819 • Issue 1 • July 2000
Page 20
© 2000, ADC Telecommunications, Inc.
Note: By default, the check box is initially left blank. It is recommended that the
program launch status scan be enabled after system hardware has been entered into the
program.
Note : A Site Map must be present to launch the status scan at start-up.
Discovery Scan – The Discovery scan will scan all defined COM ports and will detect
any new or missing units. If new equipment is detected, the program will enter the
unit(s) into the site map with no assigned parent site. The equipment must then be
updated (assigned) to parent sites within the tree. The text box displays the scan period
in milliseconds. Select the check box to start the discovery scan when the program is
launched (no site map is required).
Note: By default, the check box is initially left blank.
Note: Only RDS-2 units will be found. RDS-1 units will be ignored by the discovery
process and will not be detected.
Figure 19. “Scan” Tab
Reporting Tab
The S
WATCH
TM
program is designed to alert the user (via e-mail) when errors or warning
conditions exist. Select this tab ( Figure 20 ) for the input and selection of notification
parameters.
Note : E-mail systems must support Winsock 1.0 or better and have an operating IP
network connection.
Send Email on Failure – Select this check box to be notified if a failure occurs.