Setting Up the WAN
48
MM701G User Manual
S
ETTING
U
P THE
LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of
10.0.0.1
for the Ethernet Port IP Address, and
255.255.255.0
for the subnet mask.
1
From the
Main Menu
, select
LAN Setup
. The LAN setup screen displays.
2
Select
LAN Protocol
by typing
1
from the
LAN Setup
menu.
3
Do one of the following from the LAN Mode menu:
•
Select
Router
by typing
1.
•
Select
Bridge
by typing
2
. You must configure an IP address for the LAN port to use a
Browser or Telnet to manage the MM701G.
4
Select
IP Address
and
IP Net Mask
by typing
2
and
3
(respectively), then enter the values
supplied by your LAN administrator or use the default values.
5
Select
Default Gateway
by typing
4
from
LAN Setup
menu, then enter the
Default Gateway
IP
address supplied by your access provider.
6
Select
Apply
by typing
10
to activate your settings.
Apply
immediately activates the changes
that you have made for this session.
7
From the
Main Menu
select
Save New System Configuration
to save these settings.
LAN
1. LAN Protocol
Bridge
2. IP address
10.0.0.1
3. IP Net Mask
255.255.255.0
4. Default Gateway
5. DHCP
None
6. DHCP Range Low Address
N/A
7. DHCP Range High Address
N/A
8. DHCP Gateway Address
N/A
9. DHCP DNS
N/A
10. Apply
Select Parameter to edit (Return to exit) ->
Summary of Contents for Modem MM701G
