ADC MM702G, User Manual

Page: 40 / 168

Configure a New WAN Session
32 MM701G and MM702G User Manual
Set Up a PPPoA or PPPoE Routed Session
You selected either PPPoA routed or PPPoE routed from the WAN Configuration page to display the
following page. The PPPoA routed configuration page is shown below as an example. The
configuration parameters for PPPoE routed are identical.
1 Configure the following parameters for each session:
Session Name
Enter a unique, descriptive identifier for the session. This name can have a maximum
of 32 characters.
Virtual Path ID (VPI)
Enter the value (from 0 to 4,095) provided by the service provider. The number
identifies the virtual path that transports ATM cells between the modem and the
service provider. This value must match the virtual path identification (VPI) value
the service provider uses for this connection.